Paxton Net2 Plus door control unit in plastic housing

1 watch this article
1 sold in last 8 hours

  • Door control unit for one door at a time
  • Net2 Plus can replace a TCP/IP interface
  • Door control units can be used together in one object
  • Net2 Plus can also be connected via RS485
  • Diagnostic LEDs
  • The flash memory allows simple updates
Available immediately

Order within the next 11 hours and 32 minutes and you will receive your order between 23.7. and 24.7.
UPS Delivery Icon DHL Delivery Icon
Paxton Net2 Plus door control unit in plastic housing

Net2 Plus is a network-based access control system. Such a system offers the possibility of central management, event notification and flexible control of user access authorizations. Each door control unit is part of the network, but can also work independently. It makes its own decisions and stores events.

The Net2 Plus door control unit is connected to the management computer with an RJ45 connector via a standard TCP/IP network. This greatly increases the flexibility of installation in buildings with LAN/WAN networks. The Net2 Plus door control unit also has an RS485 connection. This allows it to be connected to other Net2 Plus or Net2 Classic door control units via a CAT5 cable.

A Net2 Plus door control unit can also act as an interface to a LAN for an RS485 connection (daisy chain) of other Net2 Plus or Net2 Classic door control units, so that they no longer require a TCP/IP interface.

Door control units are sold as an assembly, in a plastic housing or with a 2 A power supply in a plastic housing.

There is a label on the Net2 Plus door control unit that accurately shows the color-coded connections for reader, power supply, etc. The door control unit has a relay with potential-free contacts and can therefore control electric strikes or other opening drives. Door and tamper contacts, exit buttons and local alarm devices can also be connected.

Door control units communicate with the PC via the standard TCP/IP protocol of a LAN network. The Net2 Plus door control unit should be assigned a fixed IP address. All settings are made in the Net2 Configuration Utility.

The corresponding connections are equipped with diagnostic LEDs, which are helpful for trouble-free installation. Terminal resistors can be switched on or off as required. External terminal resistors are not required.

All changes entered into the PC are immediately transmitted to the door control unit and stored there. When a user presents a transponder to a reader, the user is identified by the door control unit and access is granted or denied as appropriate.

Technical data

  • Networked door control unit for one door (decentralized intelligence and high operational reliability)
  • Module, pre-assembled in plastic housing
  • Communication via TCP/IP and/or RS485
  • Readers / keypads can be connected on the entry and exit side
  • Terminal block for integration with an intruder alarm system
  • Relay contact for door opener or similar, switching capacity: 4 A at 24 V DC
  • Relay contact for control unit, switching capacity: 4 A at 24 V DC
  • Door contact, tamper contact, exit button and EV monitoring can be connected
  • Local alarm transmitter can be connected (up to max. 1 A current consumption)
  • Can be operated online and offline
  • Storage of the last 2,728 events in real time in offline mode
  • Self-detection and diagnostic LEDs for time-saving commissioning
  • Flash EEPROM for central firmware updates
  • Operating voltage: 11 - 24 V DC
  • Current consumption: 200 mA
  • Dimensions (W x H x D): 200 x 200 x 78 mm